Chapter 2
Page 40
Receiver Description and Installation
3. On Remote Control 1, press MENU-6-1-1 to display the Point Dish/Signal
screen on the nearby TV.
4. Select Check Switch. When an attention screen displays, select Retest.
5. The receiver begins performing the Check Switch tests. When it is
finished, the Installation Summary screen displays.
6. Make sure that the information on the Installation Summary screen
identifies your system correctly and shows all transponders for all satellites
in your system. Your screen may look different from the example above
depending on the dish antenna system you are using.
7. Select OK to go to the Point Dish/Signal screen.
8. Select Cancel to exit the Point Dish menu. An Attention screen will open
asking the mounting and positioning of your dish is complete with a
Locked indication in the Point Dish screen. If the answer is yes, select
Yes.
9. After you select Yes, the receiver will begin taking a software upgrade. You
will see a Warning that Vital program information will now be
downloaded into your receiver. You will also see a status bar showing the
progress of this upgrade.
10. Once the software upgrade is complete, you will see a message that your
receiver’s memory is being upgraded.
11. Do not disturb the receiver while the receiver’s memory is being upgraded.
Note: If you are installing other DISH Pro or DISH Pro Plus receivers, be
sure to run Check Switch on all of them, and allow them to take the
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV. Your
dish antenna installation is now complete.