Dukane 8912-RJ NETWORK menu, Operation, Dhcp, Dynamic Host, Configuration, Protocol, Ip Address

NETWORK menu

NETWORK menu

Remember that incorrect network settings on this projector may cause trouble on the network. Be sure to consult with your network administrator before connecting to an existing access point on your network.

From the NETWORK menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item. Then perform it according to the following table.

See the User’s Manual - Network Guide for details of network operation.

NOTE • The factory default setting for DHCP is ON. You do not have to set up DHCP, IP ADDRESS, SUBNET MASK or DEFAULT GATEWAY if your network has DHCP enabled. ( User’s Manual - Network Guide)

•If you are not utilizing SNTP ( User’s Manual - Network Guide), then you must set the date and time during the initial installation. Please refer to the item DATE AND TIME in the following table (52).

Item	Operation
	Use the ▲/▼ buttons to turn DHCP on/off
DHCP	ON  OFF
	• Select OFF when the network does not
(Dynamic Host	have DHCP enabled.
Configuration	• When the DHCP setting changes to ON, it takes a little time to
Protocol)	obtain IP address from DHCP server.
	• Auto IP function will be assigned an IP address if the projector
	could not obtain an IP address from server even if DHCP is ON.
	Use the ▲/▼/◄/► buttons to enter the IP
	address. This function can only be used when
	DHCP is set to OFF.
IP ADDRESS	• The IP address is the number that identifies
	this projector on the network. You cannot
	have two devices with the same IP address
	on the same network.
	• The IP ADDRESS “0.0.0.0” is prohibited.
	Use the ▲/▼/◄/► buttons to enter the same
SUBNET MASK	subnet mask used by your PC. This function
	can only be used when DHCP is set to OFF.
	• The SUBNET MASK ”0.0.0.0” is prohibited.

51