Dukane CAE-20W instruction manual Rear Panel Connections, Ultimate Iise

Rear Panel Connections ULTIMATE IISE

(1)DC power supply terminal [24 V IN, 1.2 A] Connect the specified AC adaptor (accessory), and it supplies 24 V DC power.

(2)Sensor input terminal [SENSOR INPUT 75Ω

(3)Line input terminals - [LINE INPUT 1,2,3,4 –20dBV 10k Ohm] Connect exter- nal audio device (such as DVD etc).

(4)Line Output terminals [LINE OUTPUT 0dBV 600 Ohm]. Connect to recording or external audio device. Output jack is 3.5mm Tip/Sleeve (monaural).

(5)Auto mute switch [AUTO MUTE OFF/LOW/HIGH] When activated, the mi- crophone can interrupt the external audio device by reducing its volume. Detec- tion sensitivity is controlled by the “LOW” and “HIGH” setting.

(6)Feedback blocker switch [FEEDBACK BLOCKER OFF/ON] Turn this switch OFF to disable feedback blocker. Default is OFF.

(7)Function terminals [PA OVERRIDE INPUT, BIAS/CNT/GND] See “Function” Page.

(8)Jumper pin—Used to set up Enable/Disable of the PA override function. Default setting is Disable

(9)Speaker Output terminals - Use speakers with impedance of 8 Ohms. Two speakers can be connected each of the four amplifiers.

(10)Ground screw [SIGNAL GND] - When the amplifier is used with a combina- tion of external devices, connect the earth terminal of each device to reduce the difference in potentials between devices.

(11)Mount for cable clamp.

16