Installation
Installation Bracket: Diagram for bending
Ceiling panel | Installation- |
| bracket |
Coaxial cable |
|
| Adjuster |
Bend it according to the | Screws | Anchor strap |
| ||
|
| |
grooves. |
|
|
Installation screw
●Installing the Sensors: Part 2
If the coaxial cables cannot be routed through the ceiling, you can install the sensors as shown below if the ceiling panels cannot be removed.
1.Bend the installation bracket. Bend the installation bracket as shown in the diagram above.
2.Attach the installation bracket to the ceiling. Attach the installation bracket to the ceiling with the screws.
3.Attach the anchor strap. Put coaxial cable through the anchor strap and tighten the adjuster.
4.Install the sensor. Put the screw through the sensor and screw it into the instal- lation bracket. Tighten the screws.
5.After installation, make sure nothing is loose. Do a visual check and make sure that nothing is unsteady and the screws are tight.
Caution: The screws for attaching the installation bracket to the ceiling panel are not provided. Procure these screws separately according to the material, construction and weight of the ceiling panel.
40
