2.Installation
2.1Unpacking and inspection
1)Unpack the packaging and check the package contents. The shipping package contains:
●A UPS
●A User Manual
●A Communication Cable
●A Battery Cable (for 6000LXL /10000LXL only)
2)Inspect the appearance of the UPS to see if there is any damage during transportation. Do not turn on the unit and notify the carrier and dealer immediately if there is any damage or lacking of some parts.
2.2Input and output power cords and protective earth
ground installation
1.Notes for installation
1)The UPS must be installed in a location with good ventilation, far away from water, inflammable gas and corrosive agents.
2)Ensure the air vents on the front and rear of the UPS are not blocked. Allow at least 0.5m of space on each side.
3)Condensation to water drops may occur if the UPS is unpacked in a very low temperature environment. In this case it is necessary to wait until the UPS is fully dried inside out before proceeding installation and use. Otherwise there are hazards of electric shock.
Installation and wiring must be performed in accordance with the local electric code and the following instructions by professional personnel.
For safety, please cut off the mains power switch before
5
