Eclipse - Fujitsu Ten CD8454 Press the Sound or RTN button to exit sound adjustment mode

How to operate the Sound Adjustment Mode

Buttons [1] to [5] [SOUND] button [SEEK ] button

[RTN] button [FAST ] button [SEL] button

4Press the [RTN] button.

At this time, other adjustments can also be made in normal mode.

5Press the [SOUND] or [RTN] button to exit sound adjustment mode.

The initial EQ settings are factory preset.

ATTENTION

Fine-tuning EQ functions

Fine adjustments can be made in each equalizer mode.

1Select the equalizer mode.

Refer to the section "Switching equalizer modes" on page 108.

2Turn the [SEL] button to select the frequency to be adjusted.

When the button is turned, the frequency changes in the following order.

63Hz ↔ 100Hz ↔ 160Hz ↔ 250Hz ↔ 400Hz ↔ 630Hz ↔ 1kHz ↔ 1.6kHz ↔ 2.5kHz ↔ 4kHz ↔ 6.3kHz ↔ 10kHz ↔ 16kHz

3Press the [SEEK /FAST ] button. This adjusts the frequency level. [SEEK ] button: Increases level. [FAST ] button: Decreases level.

4Hold down a button, [1] to [5], for more than two seconds to preset a value.

The preset value is overwritten by the value set using the above steps.

5Press the [RTN] button.

At this time, other adjustments can also be made in normal mode.

6Press the [SOUND] or [RTN] button to exit sound adjustment mode.

109