Edimax Technology ES-5224RS+ user manual User Manual, Media type, NWay, Speed, Duplex

User Manual

Default is Enable.

Auto Negotiate:

Only “Enable” and “Disable” two states can be chosen. “Enable” means the port adopted the auto-negotiation algorithm to exchange the capability with the linked partner and adjusted its speed, duplex and flow control. When enabled, the speed, duplex mode and flow control mode may change. “Disable” means the forced mode is adopted. When disabled, if you want to set up a connection successfully, you must have both port configuration of local port and linked partner be the same. If their configuration is different, the link will not be set up successfully. In the switch, the 1Gbps fiber module, it supports auto and forced modes.

Default: Auto Negotiation is enabled.

Notice: When you are in Disable mode, you must handle it carefully because this may cause the connection failed.

Speed Duplex:

Set the speed and duplex of the port. In speed, 10/100Mbps baud rate is available for Fast Ethernet, Gigabit module in port 25, 26. If the media is 1Gbps fiber, it is always 1000Mbps and the duplex is full only. If the media is TP, the Speed/Duplex is comprised of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full duplex and half duplex. The following table summarized the function the media supports.

Media type	NWay	Speed	Duplex
100M TP	ON/OFF	10/100M	Full/Half
1000M TP	ON/OFF	10/100/1000M	Full for all, Half for 10/100
1000M Fiber	ON/OFF	1000M	Full

In Auto-negotiation mode, no default value. In Forced mode, default value depends on your setting.

Flow Control:

There are two modes to choose in flow control, including Enable and Disable. If flow control is set Enable, both parties can send PAUSE frame to the transmitting device(s) if the receiving port is too busy to handle. When it is set Disable, there will be no flow control in the port. It drops the packet if too much to handle.

Default: Enable

Publication date: July, 2006

Revision A2

34