SpeedStream Dual USB/Ethernet Router User’s Guide
Model 5667
Confirm that you received all the items listed in the previous section, “Package Contents”; then position the SpeedStream router at any convenient location in your office or home. No special wiring or cooling requirements are needed. You should, however, comply with the safety guidelines specified in Chapter 1, “Introduction.”
Basic Installation Procedure
1.Install line filters (if provided).
2.Connect the cables.
3.Power up the modem and verify port status.
4.Configure network settings on your computer.
5.Configure the router via the Web interface.
6.Reboot the computer if prompted.
Another important step is to record the current router configuration in the worksheets provided in Appendix A. Although the router is already configured for your particular network, it is important to record this configuration in case it must be restored for any reason.
Installing Line Filters
Because DSL may shares the same physical line as your telephone, it may be necessary to separate the two signals so they do not interfere with each other. This is accomplished through line filters, which prevent DSL traffic from disrupting the voice signal on the phone line, and vice versa. Follow the procedure below to install line filters on any device (phones, fax machines, caller ID boxes) that shares the same phone number as the DSL line. (Note: This section may not apply to you. Consult your provider if you are unsure.)
Two types of line filters may be used. The wall mount filter is installed onto the telephone wall plate for use with
In-Line Filter
For each device that shares the DSL phone number:
1. Unplug the device’s cord from the phone jack.
2. Plug the filter into the phone jack.
3. Plug the phone cord (or other device cord) into the filter.
11
