TELEPHONE CALLS

not indicate that the radio system has been successfully accessed.

5. When the call is complete, place the microphone back on-hook.

Receiving a Standard Group Call

1.Select or scan the system and group programmed for the call you want to receive (see page 35 for scan information).

2.When the message is received, the display usually changes to the system and group of the call. Take the microphone off-hook and press the PTT switch to talk and release it to listen. If scanning, a response may not automatically occur on the group of the call.

Refer to “Transmitting In The Scan Mode” on page 39 for more information.

TELEPHONE CALLS

General

NOTE: Telephone calls can be placed and received only if that service is available to you and your transceiver has been programmed appropriately. In addition, a microphone equipped with a telephone keypad is required to dial the telephone number.

The telephone calling feature allows you to place and receive telephone calls using your transceiver. The following information describes how these calls are made with LTR-Net and LTR opera- tion. If you can make telephone calls with conventional operation, the procedure may be somewhat different and your system operator will then provide additional information. Proceed as follows:

Placing Telephone Calls

1.Turn transceiver power on and set the volume as described starting on page 15. Select the group programmed for telephone calls. To

29

Page 29
Image 29
EFJohnson 002-9803-601, 98x3, 98x6 manual Receiving a Standard Group Call, Placing Telephone Calls