![](/images/new-backgrounds/1299854/29985463x1.webp)
Chapter 4 SelfCalibration
This product is equipped with an
Attention
•To execute SelfCalibration, it is necessary to set the calibration targets etc.
•For more information, refer to
NOTE
•Use SelfCalibration as support for monitor calibration with ColorNavigator.
•When matching the measurement results of the
•SelfCalibration can also be executed when there are no computer signals being input.
4-1. Executing SelfCalibration [Calibration]
Procedure
1.Press .
The SelfCalibration menu appears.
2.Choose <Calibration> from the SelfCalibration menu, and press .
3.Select “Execute” with or
.
4.Press .
The
Attention
•To execute SelfCalibration, it is necessary to select CAL mode.
•After selecting execute, aging may be executed before the
4-2. Checking Calibration Results [Result]
The previous calibration results can be checked.
Procedure
1.Choose <Result> from the SelfCalibration menu, and press .
2.Select the mode you want to check the results for with or
. The Result menu appears.
The date and time the last SelfCalibration was executed, and the total monitor usage time from the previous calibration are displayed.
3.Select “Calibration Result” or “Ambient Light” with or
. The previous calibration results are displayed.
Attention
•The measurement results of the ambient light sensor are used to check the difference between the current environmental light level and the level of ambient light when calibration was executed, and are not reflected in the calibration results.
NOTE
•If <Ambient Light> is selected, the current environmental light is also displayed.
•Numerical values that do not reach the target values are displayed in yellow.
•If the environment in which the product is used is significantly different to the previous environment, the ambient light measurement results may differ greatly between the previous calibrations and current calibrations.
32 Chapter 4 SelfCalibration