Design Beam 1200C™
©Elation Professional® 19 Design Beam 1200C™
Be sure to follow the above figure when making your own cables. Do not use the ground lug
on the XLR connector. Do not connect the cable’s shield conductor to the ground lug or
allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the
shield could cause a short circuit and erratic behavior. If you will be using 5-Pin connectors
you may omit pins 4 and 5, see the illustration below.
DMX-512 control connection
Connect an XLR cable to the female XLR output of your controller and the other side to the
male XLR input of the f ixture (Please refer to the diagram below.). You can chain multiple
moving heads together through serial linking. Remember to daisy chain your “in” and “out”
data connections.