Design Beam 1200C™
©Elation Professional® 51 Design Beam 1200C™
16. FUSE REPLACEMENT The Design Beam 1200C has two external protective fuses. One fuse protects the internal
electronics and the other protects the lamp circuitry.
Refer to page 11 for fuse holder location.
Fuse 1, Lamp Fuse: GMA 220v/10A
Fuse 2, Electronics Fuse: GMA 220v/2A
Caution: Always replace with the exact same type fuse, unless otherwise specified by an
authorized Elation® service technician. Replacing with anything other than the specified part
can damage your unit and will void your manufactures warranty.
Warning: If you continue to blow fuses, STOP using the fixture. Contact customer support
for further instructions, yo u may have to return the unit for servicing. Continuing to use the
unit may cause serious damage.
Fuse Replacement: Locate and remove the u nit’s power cord from the main power supply.
Once the cord has been removed located the fuse holders located on the side panel near
the power input connection. Using a flat-head screwdriver unlock the fuse holder from its’
housing by turning the holder in a counter-clockwise direction. Once the fuse holder has
been unlocked, pull back on the fuse holder to expose the fuse. Gently pull out the b ad fuse
and discard of it properly and replace it with an exact match. Reassemble in reverse order.