18DoorAdjustment

ADJUSTING THE DOOR

Your door is aligned at the factory before shipment. Occasional re-adjustment may be necessary, especially if an overlay panel is installed. The following procedure will correct for up to 1/4" alignment.

The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (see Figure 21).

To adjust :

Figure 21

1

1/8”

 

 

2

 

3

Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

Remove the top hinge pivot pin with a 7/64" hex wrench (see Figure 22) and lift door off bottom hinge pin. Be careful not to lose door closers (see Figure 24).

With door upside-down, loosen but do not remove the two hinge plate screws.

Figure 22

Page 17
Image 17
Electrolux E15IM60E manual DoorAdjustment, Adjusting the Door, To adjust