Electrolux E15IM60E manual ICE Dispenser Operation & Care

Operation 23

ICE DISPENSER OPERATION & CARE

The ice cube thickness control is factory set for best overall performance. The
factory setting is designed to
maintain an ice bridge of
				Figure 28
approximately 1/16" to 1/8" under
normal conditions resulting in a						BRIDGE		BRIDGE
	1/4" TO 1/2"		1/16" TO 1/8"			TOO THIN		TOO THICK
dimple of approximately 1/4" to 1/2"					DIMPLE			LITTLE OR
	DIMPLE		ICE BRIDGE
					TOO DEEP			NO DIMPLE
in depth (see Figure 28). A fuller
cube with less of a dimple results in
a thicker ice bridge. As the ice bridge
becomes thicker, the tendency for
the cubes to stay together as a slab		GOOD					BAD
increases. A bridge thicker than 1/8"									ICE002
may cause cubes to over-fill the ice
bucket.

!WARNING

Disconnect power to the ice maker before making any ice thickness adjustments.

To adjust:

1Disconnect power to the unit.

2Remove the screws securing the front access panel (see Figure 29).

Figure 29

ACCESS PANEL SCREWS