Maintenance 29
4Remove the overflow tube by lifting it up while using a slight back and forth motion to loosen it from the drain hole (see Figure 34). The water in the reservoir will flow down the drain.
5Replace the overflow tube after all of the water has drained from the reservoir.
6Move the cycle selector switch to the CLN position.
7When water begins to flow over the evaporator (approximately 3 minutes), add one package of Electrolux Ice Machine Cleaner to the water reservoir.
8Reinstall inside front cover.
9When the
OVERFLOW |
UL209a |
Figure 34 |
10Move the cycle selector switch to the ICE/ON position to resume ice production.
Inlet Screen Cleaning — Every Year
The solenoid valve inlet screen must be cleaned at least once each year as follows:
1 | Shut off the water at the water supply valve. | Figure 35 | |
2 | Pull the unit out to access the back panel (see | ||
| |||
| Figure 35). | WATER |
CONNECTION
3Disconnect electrical power to the unit.
4Disconnect the entire hose connector from the water solenoid valve (see Figure 35).
5Use a tooth brush to clean sediment from the inlet screen. DO NOT remove the screen.
6 |
| |
valve. Tighten connector securely. Open the water |
| |
supply valve and check for leakage at the water |
| |
connection. Make sure the water supply line is not | UL103_CO | |
kinked. | ||
|
7Reconnect power to the unit before
8Make sure the drain system is working properly and the drain hose is not pinched or kinked. Pour one gallon of cool, fresh water into the ice bin. The water should drain freely. If your ice maker is equipped with a drain pump, the pump should drain the ice bin.
