14Water Supply Connection
Figure 8
UL134
Figure 9
Figure 10
1Locate the compression fitting and ferrule packed in the unit. Slide the compression fitting and ferrule over the 1/4 inch water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the supply line (see Figure 8).
2Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 9). Avoid kinking the water supply line.
3For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 10). This will also safeguard against kinking the line.
!CAUTION
After completing the installation, turn on the water and recheck water and drain connection for leaks. Apply additional tightening if needed. Do NOT use thread sealing
4Plug in the power cord.
5Gently push the unit into position. If desired the unit may be recessed into cabinet or wall.
6Allow at least
