1.1 Warnings To avoid electric arcing and hazards to personnel and electrical contacts,
never connect/disconnect the servo drive while the power source is on.
Power cables can carry a high voltage, even when the motor is not in
motion. Disconnect the Ocarina and Castanet from all voltage sources
before they are opened for servicing.
The Ocarina and Castanet servo drives contains grounding conduits for
electric current protection. Any disruption to these conduits may cause
the instrument to become hot (live) and dangerous.
After shutting off the power and removing the power source from your
equipment, wait at least 1 minute before touching or disconnecting parts
of the equipment that are normally loaded with electrical charges (such as
capacitors or contacts). Measuring the electrical contact points with a
meter, before touching the equipment, is recommended.
Cleaning after soldering
To avoid the damage of the product's acrylic coating the Flute must not be
cleaned after soldering by dissolving solvents and /or "water" cleaning
process. For more details:
www.elmomc.com/applications/article/Soldering-and-
Cleaning_Application-Note.pdf
1.2 Cautions The Ocarina and Castanet servo drives contain hot surfaces and
electrically-charged components during operation.
The maximum DC power supply connected to the instrument must
comply with the parameters outlined in this guide.
When connecting the Ocarina and Castanet to an approved 12 ~ 95 VDC
auxiliary power supply, connect it through a line that is separated from
hazardous live voltages using reinforced or double insulation in
accordance with approved safety standards.
Before switching on the Ocarina and Castanet, verify that all safety
precautions have been observed and that the installation procedures in
this manual have been followed.
Ocarina/Castanet Installation Guide Safety Information
MAN-OCSIG (Ver. 1.2)
1-2