Ocarina/Castanet Installation Guide | Installation |
| |
|
|
Pin | Short | Description |
# | Form Function |
14 ECLP External current limit peak
External voltage scales down the rated value. Voltage range: 0 V to 3.75 V (3.75 V = rated Ip) Refer to Section 4.2.
15 | LMRET | Latch | Mode | Return for Latch Mode signals. |
|
| return |
|
|
16 | GAIN | Current | gain | Shorting this pin to LMRET pin (J1/15) reduces |
|
| change |
| the proportional gain of the current loop by 70%. |
|
|
|
| |
17 | HARET | Hall | supply | Return used only for Hall supply. |
|
| voltage return |
| |
18 | HALL+ | +5 V | Hall | +5 V supply voltage for Hall sensors. |
| 5V | supply voltage | Output current: maximum of 13 mA. | |
|
|
|
| |
|
|
|
|
|
19 | SORET | Status | output | Status output common AOK, SO1, SO2, SO3. |
|
| return |
| Isolated from circuit common. See Figure |
|
|
|
| |
20 | SO2 | Status output 2 | Status indication output 2. | |
|
|
|
| Same specification as in pin J1/2. |
21 | SO3 | Status output 3 | Status indication output 3. | |
|
|
|
| Same specification as in pin J1/2. |
22 | EN- | Enable - |
| Negative voltage input of “Amplifier Enable” function. |
|
|
|
| Optocoupler is isolated from the amplifier. |
|
|
|
| For details, see pin J1/1. |
|
|
|
|
|
