MAINTENANCE

EN 31

6.3.2CUTTING DECK ALIGNMENT

The cutting deck should be properly set to obtain a good cut.

NOTE

To achieve good results from cutting, the front part should

always be 5 - 6 mm lower than the rear.

1.Put the machine onto a flat surface and check the tyre pressure;

2.put 26 mm blocks (1) under the front edge of the deck and 32 mm blocks (2) under the rear edge, then put the lifting lever into position «1»;

3.loosen the nuts (3-5), the locknuts (4-6) on the right and left-hand side and the nuts (7

– 8), so that the deck is resting firmly on the blocks;

4.tighten the nut (3) and the locknut (4);

5.turn the nut (7) until the front part of the deck just begins to rise;

6.turn the nut (5) until the rear part of the deck just begins to rise and tighten the locknut (6);

7.check the front part and if necessary, turn the nut (7);

8.tighten the nut (8) on the pin (9).

If you are unable to adjust the cutting deck properly, consult a Licensed Service Centre.

2

1

3

 

 

4

7

9

8

6

5

6.3.3ADJUSTING THE ENGAGEMENT AND BRAKE OF THE BLADE

When you operate the lever to disengage the blade, this also brings the brake into operation for stopping the blade within few seconds.

If this is faulty, contact a Licensed Service Centre.