![](/images/backgrounds/98989/98989-4236x1.png)
EN 34 | MAINTENANCE |
6.4.3ELECTRIC AND PROTECTION SYSTEM
➤In the electric start models:
The electric system and the electronic card are protected by a fuse. When it blows the machine stops, so in this case:
1.tighten the two screws (1) that fasten the box (2) containing the card, and hold up the lower part to prevent it from falling;
2.remove the lid (3) and pull out the card
(4)slightly;
3.replace the fuse (5) with another one of 6.3 A (delayed).
4.always put the lid (3) back on and refit the box (2) in its correct position.
1
2 |
| 4 |
| (6.3 Amp | |
| 3 | |
|
|
IMPORTANT | A blown fuse must |
|
always be replaced by one of the same type and ampere rating, and never with one of another rating.
If you cannot find out why the fuse has blown, consult a Licensed Service Centre.
➤In the manual start models:
The electric system and the card are not protected by any fuses. If the safety system fails to work properly or there are engine problems due to the electric system, contact a Licensed Service Centre.
6.4.4REPLACING THE BELT
The belt replacement must be carried out at a Licensed Service Centre.
NOTE | Replace the belts as soon as they show obvious signs of |
|
wear! ALWAYS USE GENUINE REPLACEMENT BELTS!