! WARNING!

EN 32

MAINTENANCE

6.3.4BRAKE ADJUSTMENT

If the braking distance lengthens, the brake will need adjusting.

The adjustment will need to be made with the parking brake ENGAGED.

1.Remove the collector channel (1), which is fixed by a pin (2) and split pin (3);

2.turn the adjusting nut (4) (which is reached by taking off the engine cover) until there is a distance of 86-88 mm between the bracket (5) and the upper part of the lever (6).

3.refit the collector channel (1) and put the pin (2) and split pin (3) back in place.

1 3

2

4

6

86 - 88 mm

5

If the brake still does not work properly even after this adjustment, immediately contact the Licensed Service Centre. DO NOT ATTEMPT ANY OTHER WORK ON THE BRAKE THAN WHAT IS DESCRIBED HERE.

6.3.5ADJUSTING THE TENSION OF THE DRIVE BELT

If you should notice that forward drive power has dropped, it will be necessary to adjust the spring

of the stretcher. Make the adjustment with the parking brake DISENGAGED (to make sure that the machine does not move) and with the cutting deck in position «3».

1.Remove the collector channel (1), fastened by a pin (2) and the split pin (3);

2.check that the cap (4) of the engagement cable is fitted firmly in its correct position;

3.turn the nuts (5) until the spring (6) reaches a total length of 174 - 176 mm measured from the outer ends of the eyelets;

3

2

1

5

 

6

4

174 - 176 mm