EN 36 |
| TROUBLESHOOTING |
|
|
|
PROBLEM | LIKELY CAUSE | SOLUTION |
4.The engine does not start
–earth connections of the microswitches disconnected
–you are not ready for starting
–faulty fuel supply
–check connections
–check that the conditions allowing the start are met (☛ 5.2.a)
–check the level in the tank (☛ 5.3.3)
–check the wiring of the fuel open com- mand
–check the fuel filter
➤ in the manual start
5.The engine stops
– faulty ignition | – check that spark plug caps are firmly |
| fitted |
| – check that the electrodes are clean and |
| have the correct gap |
– earth connections of the microswitches – check connections disconnected
6. Starting is difficult | – fault in carburation | – | clean or replace the air filter |
or the engine runs |
| – | flush out the float chamber |
erratically |
| – | empty fuel tank and refill with fresh |
|
|
| fuel |
|
| – | check and, if necessary, replace fuel |
|
|
| filter |
7.Weak engine perfor- – forward speed too high in relation to
mance during cutting | cutting height |
–reduce the forward speed and/or raise the cutting deck (☛ 5.4.5)
8. Engine stops when – you are not ready to engage the blade | – check that the safety requirements are |
blade is engaged | met (☛ 5.2.b) |