Emerson 1F95-391 manual FAQs

FAQs	1F95-391
15. How do I temporarily	Any time your program is running and you would like to override it for a specific amount
Override the program and	of time, press	or	until the temperature you want is displayed. The display will
Hold Til Timing?	indicate HOLD, and the number of hours remaining in the hold period will be indicated
	with the word HRS. To adjust the length of time for the override, press TIME FWD or
	TIME BACK. The time you select will become the new number of hours for the Hold Til
	timing. Once your time is selected, let the thermostat revert back to normal operation on its
	own to accept the change.
16. What is the	Many furnaces have safety devices that shut the system down when a lock-out condition
thermostat Click Test?	occurs in the furnace. If the thermostat is turned off or the call for heat is cancelled (by
	lowering and then raising the set temperature) the furnace may start operating again. A
	diagnostic to see if the thermostat is operating when the room temperature is below the
	thermostat setting (in heat) is to lower the setting below the room temp. Within about 3
	seconds the thermostat should make a soft click sound. This sound is the thermostat turning
	off the call for heat and usually indicates the thermostat is operating properly. If the
	thermostat does not click you would be suspicious of the thermostat and try resetting it by
	following it’s reset operation. If the thermostat does not click after being reset contact your
	heating and cooling service person or place of purchase for a replacement. If the thermostat
	clicks and the heat works intermittently contact the furnace manufacturer or local service
	person. They will want to observe the condition when it is not working.
			31

FAQs