Emerson BP7251 warranty Using the 5/64 hex wrench supplied, loosen

10-32 x 3/8"

PAN HEAD SCREW

FLAT WASHER

FAN BLADE

BLADE

FLANGE

Figure 12B

21.Attach one blade assembly to the motor hub using two 10-32 x 5/8” oval head screws (supplied) (Figure 13B). Do not tighten completely at this time. Install remaining blade assemblies in the same way. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation.

22. Pass the connectors and the wires from the motor shaft through the washer (supplied) and position the washer over the motor shaft (Figure 13B).

MOTOR HUB

BLADE FLANGE	10 - 32 x 5/8"	WASHER
		MOTOR
Figure 13B	OVAL HEAD SCREW
		SHAFT
	(2 Per Blade Assembly)

24.Securely connect the black wire from the light kit plate assembly to the blue wire from the motor shaft using a wire connector (supplied) (Figure 15B). Connect the white wire from the plate assembly to the white wire form the motor shaft using a wire connector (supplied).

WIRE

CONNECTORS

WHITE WIRES

	LIGHT KIT	BLUE
		WIRE
	PLATE ASSEMBLY
Figure 15B		BLACK
		WIRE

NOTE: When installing the light kit plate assembly, position the wires and wire connectors in the raised center portion of the plate assembly. Do not pinch wires between the light kit plate assembly and the adapter assembly.

25.Secure the light kit plate assembly to the light kit adapter assembly by threading three 5/32-32 x 3/16” phillips head screws (supplied) into the threaded holes in the adapter assembly (Figure 16B).

26.Install two candelabra base lamps in the sockets of the light kit adapter plate (Figure 16B):

Model CF2600 - 15-Watt Maximum Model CF2650 - 25-Watt Maximum

27.Position the glass shade over the threaded nipple in the light kit plate assembly (Figure 16B). Seat the glass shade evenly over the plate assembly and securely install the hex nut and finial nut (supplied) on the threaded nipple.

5/32-32 x 3/16"

PHILLIPS HEAD SCREW (3)

23. Using the 5/64” hex wrench (supplied), loosen the

setscrew in the collar on the light kit adapter

assembly. Then pass the connectors and the wires

from the motor shaft through the collar (Figure 14B).

LIGHT KIT

SOCKET

Screw the adapter assembly onto the motor shaft

and then tighten the setscrew to secure the adapter

assembly to the motor shaft. Connect the

connectors from the motor shaft using the jumper

assembly (supplied). Verify that the connectors are

securely engaged.

PLATE ASSEMBLY

THREADED NIPPLE

COLLAR

SETSCREW

	LIGHT KIT	Figure 16B
	ADAPTER ASSEMBLY
Figure 14B	JUMPER	13
	ASSEMBLY

GLASS

SHADE,

LOWER

HEX NUT 1/8-27

FINIAL

NUT