Emerson BP7251 warranty Electrical Requirements, Important Installation Information

Models: BP7251

1 16
Download 16 pages 8.42 Kb
Page 4
Image 4
Electrical Requirements

Electrical Requirements

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.

!WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with national and local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

!WARNING

To avoid possible fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician.

IMPORTANT INSTALLATION INFORMATION

Your ceiling fan contains a built-in uplight assembly in the motor housing. The fan and uplight may be controlled using one of the two following methods:

1.By an Emerson SR330 Remote Control or SW350 Wall Control.

2.By any other Emerson Fan/Light Controls or by Standard Wall Switches.

Because the procedures are widely different, they have been separated into different sections. Determine how you are going to control your fan, then select the appropriate Installation Section from the list below.

SECTION Title

Use

Page No.

1. Assembly Instructions for Installing

Section “A”

5

the CF2600 and CF2650 Ceiling Fan with

 

 

the Emerson SR330 Remote Control or

 

 

the SW350 Wall Control

 

 

2. Assembly Instructions for Installing

Section “B”

10

the CF2600 and CF2650 Ceiling Fan

 

 

Controlled by Emerson Fan/Light

 

 

Controls (other than SR330 or SW350)

 

 

or Standard Wall Switches

 

 

4

Page 4
Image 4
Emerson BP7251 warranty Electrical Requirements, Important Installation Information