Emerson BP7251 warranty Section a

SECTION A

Assembly Instructions for Installing the CF2600 and CF2650 Ceiling Fan with the Emerson SR330 Remote Control or the SW350 Wall Control

1.Obtain the hanger ball/downrod assembly and remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1A). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in Step 16.

PIN

HANGER BALL

DOWNROD SETSCREW

Figure 1A

2.Push the wiring harness connector (supplied with the SW375 Receiver), the connector on the blue wire (supplied with the SR330 or SW350 Control), and the connector on the yellow uplight lead (supplied with the fan) through the downrod until they extend about 4” out of the pipe (Figure 2A).

INSULATE BLACK

WIRE USING WIRE

CONNECTOR

BLACK WIRE

BLUE WIRE

WHITE

3" WIRE

YELLOW WIRE

Figure 3A

7.Using wiring connectors (supplied), connect the white, blue and yellow wires from the downrod to the white, blue and yellow wires from the fan motor (Figure 4A and 6A). Wires must be connected color-to-color.

REMOVE WIRE CONNECTOR

FROM BROWN WIRES

REMOVE WIRE CONNECTOR FROM RED WIRES

CONNECT

YELLOW WIRES

4"

WIRING

HARNESS

Figure 2A

YELLOW UPLIGHT LEAD

BLUE WIRE	CUT HERE
DOWNROD	3"

CONNECT WHITE WIRES

Figure 4A

DOWNROD

CONNECT BLUE WIRES

3.	Cut the harness wires approximately 3” from the
	end of the downrod (Figure 2A). Strip insulation
	1/2” from end of wires.
4.	Position the motor housing and shade assembly in
	the upper foam packing so that the top of the

8.Remove the wire connectors from the red wires and the brown wires (Figure 4A).

9.Cap the red and the brown wires from the reversing switch using a wire connector on each wire (Figure 5A).

	motor is facing you.
5.	Separate, untwist and unkink the three motor
	leads.
6.	Cut the white, blue and black wires about 3” above
	the motor coupling (Figure 3A). Strip insulation
	1/2” from end of the white and blue wires. Install a
	wire connector on the black wire; this wire will not
	be used.

SLOT IN MOTOR COUPLING

REVERSING SWITCH

CAP BROWN AND RED

USING WIRE CONNECTORS

CONNECT

RED WIRES

CONNECT

BROWN WIRES

DOWNROD

Figure 5A

10.Using wiring connectors (supplied), connect the red and brown wires from the downrod to the red and brown wires from the fan motor (Figure 5A and 6A). Wires must be connected color-to-color.

5