Installation of the Decorative Support Rods Assembly
NOTE: The following procedures are to be performed only if you have installed the 18” or longer downrod.
1.Loosen the setscrew in the collar of the rod support assembly using the 5/64” hex wrench (supplied) and slide the support assembly over the downrod (Figure 1).
4.Raise the rod support assembly and loosely engage the rod hook with one of the rings on the support assembly (Figure 3). Then tighten the setscrew using the 5/64” setscrew.
| RING |
ROD SUPPORT | LOOSELY |
ENGAGE | |
ASSEMBLY | ROD HOOK |
| WITH RING |
ROD SUPPORT | SETSCREW |
ASSEMBLY |
|
SETSCREW
DOWNROD
Figure 3
Figure 1
2.Verify that three or four threads are visible between the bottom hook and the barrel of the rod assembly (Figure 2). If necessary, turn barrel to expose more threads. Check all rod assemblies.
3.Engage the rod hook with the ring in the shade assembly (Figure 2).
SHADE ASSEMBLY
BARREL (ROTATE THE
BARREL TO REMOVE
SLACK IN ROD
ASSEMBLY, SEE STEP 6)
THREADS
HOOK
RING
Figure 2 | 14 |
|
5.Engage the other two support rods in the same manner as above. Loosen the setscrew and raise the rod support assembly until the support rods are taut and in line with the downrod (Figure 4). Then securely tighten the setscrew using the 5/64” hex wrench.
6.Tighten (rotate) the barrels of the rod assemblies to take up any slack, thereby reducing the chance of noise due to vibration when the fan is operating (Figure 2).
CAUTION: To avoid breaking the glass shade, do not over tighten the rods.
NOTE: The decorative support rods are now installed and the fan is ready for further installation. Continue with Step 15 in SECTION A, or Step 10 in SECTION B.
|
| SETSCREW |
| SUPPORT | DOWNROD |
| RODS SHOULD | |
|
| |
Figure 4 | BE IN LINE |
|
WITH |
| |
| DOWNROD |
|
