Emerson BP7251 warranty Unpacking Instructions, Tools Needed for Assembly

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
Five wire connectors (supplied)	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan. If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding

your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson. Substitution of parts or accessories not designated for use with this product by Emerson could result in personal injury or property damage.

1.Open carton containing your ceiling fan. Remove the top half of the styrofoam packing. Remove parts and check to see that you have received the following:

a.Fan motor and shade assembly

b.One motor cover

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One yellow lead assembly uplight

h.One downrod, 18” length

i.Three rod assemblies

j.One rod support assembly

k.One light kit plate assembly

l.One light kit adapter assembly

m.One glass shade

n.One loose parts bag containing:

1.One setscrew

2.One 5/32” hex wrench

3.One 5/64” hex wrench

4.Eleven 10-32 x 5/8" oval head screws

5.Two 1” threaded studs

6.Two 1-1/4” threaded studs

7.Four knurled knobs

8.Four lockwashers

9.Five wire connectors

10.Three 5/32-32 x 3/16" screws

11.One finial nut

12.One hairpin clip

13.One clevis pin

14.Sixteen 10-32 x 3/8” pan head screws

15.Sixteen flat washers

16.One jumper assembly

17.One washer, motor shaft

18.One hex nut 1/8-27

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

NOTE: Fan blades are ordered separately and are packaged in separate carton.

FAN MOTOR

HOUSING AND

SHADE ASSEMBLY

		YELLOW
		LEAD
		ASSEMBLY
		UPLIGHT
LOOSE		HANGER BALL/
PARTS
		DOWNROD
BAG	MOTOR
		ASSEMBLY
	COVER
		HANGER
		BRACKET
BLADE
FLANGES		LIGHT KIT
CEILING
		PLATE
COVER
		ASSEMBLY
ROD SUPPORT
ASSEMBLY
		LIGHT KIT
		ADAPTER
		ASSEMBLY
		GLASS
		SHADE
		18" DOWNROD
3		ROD ASSEMBLY (3)