Installation
2.0INSTALLATION
2.1Unpacking and Inspection
Unpack the UPS and conduct the following checks:
•Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and your local dealer or your Emerson representative immediately.
•Check the accessories included in packaging list. If there is any discrepancy, contact your local dealer or your Emerson representative immediately.
2.2What’s Included
With GXT3 UPS
•Compact Disk with:
•Liebert MultiLink®
•Configuration Program
•User Manual
•Terminal Block Communication terminals
•USB Cable: one,
•Mounting hardware, including screws and handles
•Plastic tower stand sets: 2 (four pieces)
•Warnings, Safety Instructions booklet and WEEE recycling sheet (ISO 14001 compliance)
NOTE
The GXT3 External Battery Cabinet shipping package includes one battery cabinet, two spacers for tower configuration and one DC power cable.
2.3Preparation for Installation
2.3.1Installation Environment
•Install the UPS indoors in a controlled environment, where it cannot be accidentally turned Off. The installation environment should meet the specifications listed in 9.0 - Specifications).
•Place it in an area of unrestricted airflow around the unit, away from water, flammable liquids, gases, corrosives, and conductive contaminants. Avoid direct sunlight.
NOTE
Operating the Liebert GXT3™ in temperatures above 77°F (25°C) reduces battery life.
Installation Clearances
Maintain at least 4 inches (100mm) clearance in the front and rear of the Liebert GXT3. Do not obstruct the air inlets on the front panel and rear panel of the UPS; blocking the air inlets reduces ventilation and heat dissipation, shortening the service life of the Liebert GXT3.
11
