Emerson 208V, GXT3 Installing front member of each slide rail assembly, Installing inner members

Installation

5.Extend the slide rail assembly by sliding the front member forward until it touches the rack’s front vertical rails (adjustable length: 18 to 32 inches [457-813mm]). Use two M5 screws to fix each front member onto the front vertical rails through the installation holes. Make sure that slide rail assemblies are at the same mounting height on all four rack rails, as shown in Figure 13.

Figure 13 Installing front member of each slide rail assembly

Front
Vertical
Pole	Slide
Front
Member
M5 Screw
4 pieces	Rear
	Member

6.Fasten rear member and front member together using four M4 screws and four M4 nuts (M4 nuts have been factory-installed on the rear member) per slide rail assembly, as shown in Figure 14.

Figure 14 Fastening rear member and front member together

Rear Member

M4 Screw, 8 pieces

Front member M4 Nut, 8 pieces

7.Fasten inner members pulled from the slide rail assemblies in Step 2 to the UPS on both sides with eight M4 screws provided in this kit. Make sure that the retaining latch is near the rear of the UPS, as shown in Figure 15.

Figure 15 Installing inner members

Liebert GXT3 UPS

Inner Member

Retaining Latch

M4 screw, 8 pieces

8. Use M4 screws to install ears of accessories on both sides of the UPS, as shown in Figure 16.

15