Emerson 208V, GXT3 Removing the front bezel cover and battery door, Pull out the battery

Maintenance

Figure 22 Removing the front bezel cover and battery door

Battery Door

Screws, 6

Front Bezel

4.Gently pull the battery wire out and disconnect the battery plug and battery receptacle, as shown in Figure 23.

Figure 23 Disconnecting the battery plug and battery receptacle (front view)

Battery Connector Battery Receptacle

5.Grasp the battery handle, and pull the internal battery pack out of the UPS, as shown in Figure 24.

Figure 24 Pull out the battery

Internal Battery Pack

Battery

Handle

Pull Out with Battery Handle

6.Unpack the new internal battery pack. Take care not to destroy the packing.

Compare the new and old internal battery pack to make sure they are the same type and model. If so, proceed with Step 7; if they are different, stop and contact your local Emerson representative, or Emerson Channel Support.

7.Line up and slide in the new internal battery pack.

8.Reconnect the battery plug and battery receptacle

9.Push the battery wire and internal battery pack back into the UPS.

10.Reattach the front battery door with the six screws.

11.Reattach the front plastic bezel cover to the UPS.

NOTE

The internal battery pack is hot-swappable. However, caution should be exercised because during this procedure the load is unprotected from disturbances and power outages. Do not replace the battery while the UPS is operating in Battery Mode. This will result in a loss of output power and will drop the connected load.

29