Emerson GXT3-6000RT208 user manual Configuration Program Features, What You Will Need

Configuration Program

6.0CONFIGURATION PROGRAM

The final step of installation may require custom configuration of your UPS using the enclosed config- uration program. Some configuration settings may be changed only while the UPS is off. These should be set before the UPS is put into full-time service powering the critical load.

For most users operating with 230VAC and with no external batteries, the factory default settings will be adequate.

6.1Configuration Program Features

•Select L-N output voltages to match local voltages.

•Enable/Disable Auto-Restart.

•Select frequency converter operation with a fixed output frequency of 50 or 60 Hz.

•Set the Low Battery Warning alarm time from 2 to 30 minutes.

•Enable/Disable the Auto-Battery test.

•Set the Auto-Battery test to 7, 14, 21 or 28 days.

•Specify the number of external battery cabinets connected to the UPS to adjust the remaining run time calculations reported by Liebert® software products.

•Modify the shutdown setting of the terminal block (for information on pin assignments, see Table 2).

6.1.1What You Will Need

In addition to the Liebert GXT3™ UPS, you will need the configuration program CD and USB cable included in the UPS accessory box. A Windows 95® or later computer, desktop or laptop, is also required to set up and run the configuration program.

22