Emerson MVME55006E manual Ethernet

Hardware Preparation and Installation Ethernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6, J7, J28,

The MVME5500 is factory tested and shipped with the configuration described in the following section.

Figure 1-1 MVME5500 Board Layout

PMC 2

PMC 1
ABT/RST
GigE	ENET
	1
10/100	ENET 2
CPU BFL	COM1

4436 0207

J2

J1

J5

U1

		J18		U29	J27		J8
U7		U19	U28		U30
U6					J21	J22
U5	U16	U25
U4								J102 - J110
XU2		XU1						1
							P1
				J23		J24
			J102 - J110					3
	S4	S3
U15		U18	U27
		U23
	U17
U14		U129			J11		J3	J32
	P4						J6 / J100
							J99	1
							J98
U13	U12						J34
						J12	J97
							J101 / J7
	U11							3
U3		U22
							J33
				J13		J14
	U10
U2
			U26				J32
U9		U20
			U126
U8		U125
S2			S5
S1
	U123						P2
		U24						J28
					U31			1
	U124
								3
			J4				J28

1.6.2Ethernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6, J7, J28, J32, J34, J97 – J110)

All of the headers described below are used in conjunction with each other to select various modes of operation for 10/100BaseT Ethernet, PMC/SBC mode, and P2 I/O mode.

1.6.2.1Ethernet

Four 3-pin planar headers (J6, J7, J100, J101) and four 2-pin planar headers (J34, J97, J98, J99) are for 10/100/BaseT Ethernet 2 selection.

Ethernet 1 is the Gigabit Ethernet port and is front panel only.

20 MVME55006E Single-Board Computer Installation and Use (6806800A37D)