Emerson MVME55006E manual Secondary PMCspan

Hardware Preparation and Installation Secondary PMCspan

6.Gently press the PMCspan and MVME5500 together and verify that P4 is fully seated in J4.

7.Insert four short screws (Phillips type) through the holes at the corners of the PMCspan and into the standoffs on the MVME5500. Tighten screws securely.

1.8.3Secondary PMCspan

The PMCspanx6E-010 PCI expansion module mounts on top of a PMCspanx6E-002. To install a PMCspanx6E-010, perform the following steps while referring to the figure on the next page:

Personal Injury or Death

Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing and adjusting.

Product Damage

Inserting or removing modules with power applied may result in damage to module components.

Avoid touching areas of integrated circuitry, static discharge can damage these circuits.

Procedure

This procedure assumes that you have read the user’s manual that was furnished with the PMCspan, and that you have installed the selected PMC modules on your PMCspan according to the instructions provided in the PMCspan and PMC manuals.

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical ground. Note that the system chassis may not be grounded if it is unplugged. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove chassis or system cover(s) as necessary for access to the VME module

3.If the Primary PMC Carrier Module and MVME5500 assembly is already installed in the VME chassis, carefully remove it as shown in Figure 1-17and place it with connectors P1 and P2 facing you.

4.Remove four screws (Phillips type) from the standoffs in each corner of the primary PCI expansion module.

32 MVME55006E Single-Board Computer Installation and Use (6806800A37D)