Emerson MVME55006E manual Connection to Peripherals, MVME5500 Connectors, Connector Function

Hardware Preparation and Installation Connection to Peripherals

5.Slide the MVME5500 into the chassis until resistance is felt.

Figure 1-17 Installation into a Typical VME Chassis

6.Simultaneously move the injector/ejector levers in an inward direction.

7.Verify that the MVME5500 is properly seated and secure it to the chassis using the two screws located adjacent to the injector/ejector levers.

8.Connect the appropriate cables to the MVME5500.

1.9.1Connection to Peripherals

When the MVME5500 is installed in a chassis, you are ready to connect peripherals and apply power to the board.

Figure 1-1 on page 20 shows the locations of the various connectors while Table 1-3lists them for you. Refer to Chapter 5, Connector Pin Assignments for the pin assignments of the connectors listed below.

If a PMC module is plugged into PMC slot 1, the memory mezzanine card cannot be used because the PMC module covers the memory mezzanine connector.

Table 1-3 MVME5500 Connectors

	Connector	Function
	J1	COM1 front-panel connector
	J2	Dual 1000/100/10BaseT front-panel connectors
	J3	IPMC connector
	J4	PCI/PMC expansion connector
	J5	CPU COP connector
	J11, J12, J13, J14	PMC 1 connectors
34		MVME55006E Single-Board Computer Installation and Use (6806800A37D)