Emerson MVME55006E manual Installing the RAM5500 Module, Procedure

Hardware Preparation and Installation Installing the RAM5500 Module

1.7Installing the RAM5500 Module

Procedure

To upgrade or install a RAM5500 module, refer to and proceed as follows:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Perform an operating system shutdown. Turn the AC or DC power off and remove the AC cord or DC power lines from the system. Remove the chassis or system cover(s) as necessary for access to the VME boards.

3.Carefully remove the MVME5500 from its VME card slot and lay it flat, with connectors P1 and P2 facing you.

4.Inspect the RAM5500 module that is being installed on the MVME5500 host board to ensure that standoffs are installed in the four mounting holes on the module.

5.With standoffs installed in the four mounting holes on the RAM5500 module, align the standoffs and the P1 connector on the module with the four holes and the P4 connector on the MVME5500 host board and press the two connectors together until they are firmly seated in place.

4237 0903

6.Turn the entire assembly over and fasten the four short Phillips screws to the standoffs of the RAM5500.

28 MVME55006E Single-Board Computer Installation and Use (6806800A37D)