Emerson MVME55006E manual Startup and Operation, Applying Power, Switches and Indicators

Completing the InstallationHardware Preparation and Installation

Table 1-3 MVME5500 Connectors (continued)

Connector	Function
J18	Boundary scan connector
J21, J22, J23, J24	PMC 2 connectors
J33	COM2 planar connector
P1, P2	VME rear panel connectors
P4	Memory expansion connector

1.9.2Completing the Installation

Verify that hardware is installed and the power/peripheral cables connected are appropriate for your system configuration.

Replace the chassis or system cover, reconnect the system to the AC or DC power source, and turn the equipment power on.

1.10Startup and Operation

This section gives you information about:

zThe power-up procedure

zSwitches and indicators

1.11Applying Power

After you verify that all necessary hardware preparation is complete and all connections are made correctly, you can apply power to the system.

When you are ready to apply power to the MVME5500:

zVerify that the chassis power supply voltage setting matches the voltage present in the country of use (if the power supply in your system is not auto-sensing)

zOn powering up, the MVME5500 brings up the MotLoad prompt, MVME5500>

1.12Switches and Indicators

The MVME5500 board provides a single push button switch that provides both Abort and Reset (ABT/RST) functions. When the switch is depressed for less than three seconds, an abort interrupt is generated to the processor. If the switch is held for more than three seconds, a board hard reset is generated.

MVME55006E Single-Board Computer Installation and Use (6806800A37D) 35