Emerson Process Management 760004-A 4-6ELECTRONICS ASSEMBLY, Figure 4-11.Removing Electronics Assembly from Chassis

Instruction Manual

760004-A February 2002

Model NGA 2000 HFID

4-6 ELECTRONICS ASSEMBLY

The electronics assembly must be removed from the chassis if replacement of any of the following components is necessary:

Power Supply Board

Sensor Board

Case Temperature Sensor

Case Pressure Switch

1.Remove the hex nut and screw as shown in Figure 4-11.

Safety Board	2. Lay electronics assembly on bench,
Computer Analysis Board	do not disconnect cables or tubing.
Preamp Assembly

Electronics Assembly 656943

Screw

Hex Nut

Figure 4-11. Removing Electronics Assembly from Chassis

4-14 Maintenance and Service Rosemount Analytical Inc. A Division of Emerson Process Management