Model NGA2000 HFID

Instruction Manual

748297-E June 2003

Replacing front panel components

1.To access components, remove the four front panel mounting screws (two on front, one on each side).

2.Remove the burner air regulator and fuel regulator mounting nuts.

3.Remove the purge air regulator mounting bracket screws.

4.The front panel can now be pulled away from the chassis.

Note

The wiring from front panel components is still connected. Do not disconnect unless replacing that component.

Front panel attaching screw

Front panel

(opposite side also)

attaching screws

Figure 4-21. Accessing Front Panel Components

Rosemount Analytical Inc. A Division of Emerson Process Management

Maintenance and Troubleshooting 4-23