Using LANVIEW

 

 

Table 4-1 LANVIEW LEDs

 

 

 

 

 

 

 

 

 

LED

Color

State

Recommended Action

 

 

 

 

 

 

 

 

CPU

Off

Power disconnected.

If the LED remains off after connecting AC

 

 

 

 

 

power or DC power from an RPS, check

 

 

 

 

 

the following:

 

 

 

 

 

1. Make sure there is power at the power

 

 

 

 

 

source (AC source and RPS if

 

 

 

 

 

applicable).

 

 

 

 

 

2. Replace the power cord with a known

 

 

 

 

 

good one or check the continuity of the

 

 

 

 

 

power cord.

 

 

 

 

 

3. If the SecureStack A2 still does not

 

 

 

 

 

power up, the system may have a fatal

 

 

 

 

 

error. Contact Enterasys Networks for

 

 

 

 

 

technical support.

 

 

 

 

 

 

 

 

 

Red

Solid. Boot-up failed.

If the LED remains red for several

 

 

 

 

 

minutes, the system may have a fatal

 

 

 

 

 

error. Contact Enterasys Networks for

 

 

 

 

 

technical support.

 

 

 

 

 

 

 

 

 

 

Blinking. Diagnostics have

Contact Enterasys Networks for technical

 

 

 

 

failed.

support.

 

 

 

 

 

 

 

 

Amber

Solid. Diagnostics are running. If the LED remains amber for more than

 

 

 

 

 

several minutes, contact

 

 

 

 

 

Enterasys Networks for technical support.

 

 

 

 

 

 

 

 

 

 

Blinking. Code image is being

None.

 

 

 

 

downloaded, or the Manager

 

 

 

 

 

switch is copying its

 

 

 

 

 

configuration to the other

 

 

 

 

 

members in the stack (this

 

 

 

 

 

happens automatically every

 

 

 

 

 

15 minutes and every time the

 

 

 

 

 

“save config” command is

 

 

 

 

 

executed.

 

 

 

 

 

 

 

 

 

 

Green

Solid. System is fully

None.

 

 

 

 

functional.

 

 

 

 

 

 

 

 

 

 

 

Blinking. Boot-up in process.

None.

 

SecureStack A2 Installation Guide 4-3

Page 65
Image 65
Enterasys Networks A2H254-16 manual Lanview LEDs, Color State Recommended Action