Access Point Configuration | Enterasys Networks RBT-4102 manual

Access Point Configuration

b.Click the DHCP Client: Disable radio button. DHCP allows you to enable or disable the option to obtain the IP settings for the access point from a DHCP (Dynamic Host Configuration Protocol) server. The IP address, subnet mask, default gateway, and Domain Name Server (DNS) address are dynamically assigned to the access point by the network DHCP server. Default: Enable

c.Enter the IP Address, Subnet Mask, Default Gateway, and Primary and Secondary DNS.

Note: Enterasys Networks recommends that you reset the access point after changing the DHCP client status.

•IP Address is the IP address of the access point. Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods.

•Subnet Mask is the mask that identifies the host address bits used for routing to specific subnets.

3-10

Image 50

Enterasys Networks RBT-4102 manual Access Point Configuration

Contents

Enterasys RoamAbout Page Page Compliances RBT-4102, RBT-4102-BG, and RBT-4102-EU Industry Canada Statement RBT-4102-EUIii EC Conformance Declaration Operation Using 5 GHz Channels in the European Community Usage RBT-4102C and RBT-4102C-EU Vii RBT-4102C-EU ViiiPage Operation Using 5 GHz Channels in the European Community EC-Konformitätserklärung Xii English Xiii Italian IT Power Cord Set Xiv Power Cord Set Hazardous Substances Xvi Xvii You and Enterasys agree as follows Xviii Xix Compliances Xxi Xxii Table of Contents Appendix C Specifications Xxiv Intended Audience PrefacePurpose Associated Documents World Wide Web Phone Getting HelpXxvi Introduction Top Panel Package ChecklistHardware Description Hardware Description Rear Panel Component Description External Antenna ConnectorsLED Indicators Antennas Status Description Security SlotConsole Port Ethernet Port Reset Button Power Connector Introduction Hardware Installation Hardware Installation Page Hardware Installation Required Connections Access Point ConfigurationUsing the CLI Access Point Configuration Logging Using the CLI Enter no ip dhcp to disable Dhcp Using the CLI Using Web Management Using Web Management Access Point Configuration Using Web Management Access Point Configuration Using Web Management Access Point Configuration Using Web Management Access Point Configuration Network Configuration Ad Hoc Wireless LAN no Access Point Network Topologies Infrastructure Wireless LAN Infrastructure Wireless LAN for Roaming Wireless PCs Infrastructure Wireless Bridge Network Configuration Troubleshooting Chart Appendix a TroubleshootingDiagnosing Access Point Indicators Symptom Action Troubleshooting Appendix B Cables and Pinouts Twisted-Pair Cable Assignments Pin MDI Signal Name MDI-X Signal Name 10/100BASE-TX Pin Assignments Straight-Through Wiring Crossover Wiring Wiring Map for Serial Cable Console Port Pin Assignments Maximum Channels Appendix C SpecificationsGeneral Specifications Data Rate Unit Power Supply Network ConfigurationAC Power Adapter Modulation Type Temperature WeightLED Indicators Physical Size Compliances Radio Signal CertificationSafety Standards Ieee 802.11b Data Rate SensitivityIeee 802.11g Data Rate Data Rate 15-5.250 25-5.350 50-5.700 725-5.825 Transmit PowerIeee 802.11a 802.11b Wireless Distance Table Speed and Distance Ranges1 802.11a Wireless Distance Table Speed and Distance Ranges1802.11g Wireless Distance Table Speed and Distance Ranges1 Operating Range External Antennas External Antennas Specifications Index Index-1 Index-2