Installation
INSTALLATION OF THE SURROUND PANEL - INSERT:
Installation of Trim:
The trim set for your surround panel must be installed before installing the surround panel onto the unit, if not already done.
1.Attach one side trim to the top trim, using a corner bracket (see Figure 53) to secure pieces together. There are two (2) main pieces to each corner bracket (see
Figure 54). When installing the corner pieces into the trim, the “B FACE” sides must face each other
Figure 53: Corner brackets for trim. and the screw heads are to face
out. With the bracket in place and
the top and a side trim snug together, use |
|
a flat head screwdriver to turn the two (2) |
|
Figure 54: Two pieces of corner | |
screws in the bracket to tighten it into the | bracket. |
trim. |
|
Figure 55: Screw to hold the trim against the sur- round.
3.Slide the two (2) attached trim pieces onto the surround panel.
4.Attach the other side trim piece to the top trim, using the same method used in Step 1.
5.Place the second side of the trim on the surround panel in the same manner used on the first side and secure in the same manner.
6.On the side trims, there are holes 2” (50 mm) from either end. Use a Phillips screwdriver to place a #8 screw 11⁄4” long in each hole and tighten (refer to Figure 55). This will keep the
trim tight against the surround.
Installation of Surround Panel onto Unit:
There are two (2) hooks on either side of the inside of the panel. Line up the openings on the hooks with the screws on the outside of either shroud (see Figure 56). Push the surround in and push it down into place.
Figure 56: Installation of Panel.
41
