Enviro 1700 Fireplace Freestanding, C-11116, 1700 Insert, 1200 Insert owner manual Venting

Installation

MASONRY FIREPLACE INSTALLATION - FREESTANDING:

Rain Cap

Chimney

Support and Clamp

Rigid Stainless

Steel Liner

Listed Liner

Stove pipe must end higher than liner

Steel Plate or Flashing

Unless you are experienced, we recommend installation by your dealer or a professional installer.

Many venting manufacturers have listed kits available to connect a stove to a masonry fireplace. Always follow the vent manufacturer’s installation instructions.

The existing damper may have to be removed to allow installation.

Flexible Stainless

Steel Section

Clean-out tee

Damper Removed or Fastened Open

Stainless Steel

Connector Pipe

Clean-out
cover	Masonry Fireplace
	Floor Protection
	Combustible Floor

Figure 29: Freestanding Installation into existing fireplace.

MOBILE HOME INSTALLATION:

SPECIAL REQUIREMENTS: Pedestal models 1200 and 1700 are approved for mobile homes. A 1200 or 1700 Insert may also be installed into a Mobile Home in the U.S. provided there is a Mobile Home approved Factory Built Fireplace installed with adequate fresh air supply, and that that Factory Built Fireplace is not altered beyond the damper or ash shelf being modified. In Canada, Insert Mobile Home installations must be pre-approved by the local inspector. All freestanding installation requirements in “Installation Of A Listed, Factory Built Chimney”, must comply with all local codes that may apply, and the following must be met:

VENTING:

In Canada: Any ULC-S629 listed chimney system with the accompanying double-wall vent connector.

In U.S.A. Any UL-103-HT listed chimney system with the accompanying double-wall vent connector. Do not connect a listed chimney of one manufacture with a listed double wall connector from another manufacture.

28