QBecause most software takes care of the top and bottom margins, you should usually adjust the margins by using your software, taking the printer’s default loading position into account.

c3 You can use the printer’s micro-feed feature to adjust the paper loading position or to adjust the current print position during a print job. See below.

Adjusting the loading position

The loading position is the position of the paper when the printer loads it. If printing is too high or low on the page, change the loading position with the micro-feed feature.

1.Make sure the printer is turned on.2.Load a sheet of paper from the paper feeder by pressing theLOAD/EJECT button.3.Open the printer cover and the paper feeder cover.

4.As soon as the paper is loaded, hold down the ALT button and press the ECONOMY/CONDENSED button to move the loading position up l/180 inch, or the FONT button to move the loading position down l/180 inch. Continue pressing the appropriate button until you reach the position you want.

5.Close the printer cover and the paper feeder cover.6.Send data from the computer to start printing.

Ll The printer has a minimum and maximum loading position. If you try to move the loading position beyond these limits, the printer beeps and the paper stops moving.

Ll When the paper reaches the factory-set loading position, the printer beeps. Use the factory setting as a reference point when adjusting the loading position.

Paper Handling 2-3