If the perforation is not aligned with the tear-off edge, adjust the tear-off position as follows:

1.Make sure the paper is in the tear-off position.2.While holding down the ALT button, press the

ECONOMY/CONDENSED (up) or FONT (down) button to adjust the position. The printer remembers the new position even after you turn it off.

3.Tear off any printed pages.

Note:

QThe printer has a minimum and maximum tear-offposition. If you try to move the tear-ofiposition beyond these limits, the printer beeps and the paper stops moving.

UWhen the paper reaches the factory-settear-off position, the printer beeps. Use the factory setting as a reference point when adjusting the tear-oflposition.

Removing the push tractor

1.Tear off any printed pages. Press the LOAD/EJECT button to feed the paper backward out of the printer and into the paper-park position. Remove the paper from the push tractor.

R Caution:

U Never feed labels backzuard. To remove labels from the printer, see “Labels“ later in this chapter.

UMake sure you tear offyour printed document before feeding paper backzuard. Reverse feeding several pages at a time may cause a paper jam.

2.Turn off the printer. Attach the paper separators as shown on page l-6.3.Lower the release lever to the single-sheet position.

Paper Handling 2-13