
Adjusting Video Settings (Image Source = Computer)
You can adjust the projected image by using the Video menu. The following options are available when the image source is Computer.
Note: The computer must be connected and operating, and the image source on the projector must be set to Computer for you to access these menu options. To change the image source on the projector, press the Source button on the remote control or control panel.
Menu item | Description |
| ||
|
|
|
|
|
Position | Select this item by pressing the Enter |
|
| button (control panel) or the |
|
| |||
| ||||
| top or bottom | |||
| (H/V) adjustment mode. Then use the pointer button (remote) or up, | |||
| down, left, and right buttons (control panel) to move the screen position | |||
| in the corresponding direction. |
| ||
| When you finish making adjustments, press the Menu button on the | |||
| control panel or the remote to return to the Video menu. | |||
Tracking | Matches the projector’s internal clock to various computer graphic | |||
| signals. Adjust this setting to remove vertical lines from the image. | |||
Sync. | Synchronizes with the tracking signal sent from the computer. Adjust | |||
| this setting to correct fuzziness or screen flicker. | |||
Brightness | Lightens or darkens the overall image. Increase brightness to lighten an | |||
| image, or decrease it to darken the image. |
| ||
Contrast | Adjusts the difference between light and dark areas. Increase the | |||
| contrast to make light areas lighter and dark areas darker. Decrease it to | |||
| minimize the difference between light and dark areas. | |||
|
|
|
|
|
72 | 3 • Adjusting Projector Settings |