Note:

If you want to share the new printer, click Share the Printer on the Network. The share name defaults to the printer name; you can change it if necessary. For more information about sharing, see your Windows NT documentation.

Setup Guide

6.Type a name for the port in the Name box. Make sure the name is not the same as an existing port, such as LPT1.

7.Select the target node address from the Card Address list. Make sure this address matches the one listed under Node Number on the status sheet.

8.Click the Timers button and select the Job Based option. Then click Close.

9.Click Next, then follow the instructions on the screen for printer driver installation.

Configuring the Ethernet Card in Windows NT 3.5x

After you have installed the DLC protocol, follow these steps to configure the card and your printer for Windows NT 3.5x:

1.Double-click Print Manager in the Main group.

2.Choose Create Printer from the Printer menu. The Create Printer dialog box appears.

3.Type a name for the printer. Then select the printer driver from the Driver menu. Select Other from the Print To menu. The Print Destinations dialog box appears.

4.Choose Hewlett Packard Network Port from the Available Print Destinations list.

5.Type a name for the port in the Name box. Make sure the name is not the same as an existing port, such as LPT1.

6.Select LAN Hardware Address (Node Address) from the Card Address list. This address matches the one listed under Node Number on the status sheet.

7.Click the Timer button and select the Job Oriented option. Then click OK. Click OK again to exit the dialog box.

21