Epson 8900 Series manual Line Feed and Carriage Return Upon Receipt of CR, Graphics

Line Feed and Carriage Return Upon Receipt of CR

When on, this parameter causes the printer to perform both an LF operation and a CR operation upon receiving a CR command from the host computer. The default setting is OFF.

Carriage Return Upon Receipt of LF, VT, or DC2

When on, this parameter causes the printer to perform a CR operation upon receiving any of the following commands.

qLine feed (LF) — The printer moves the printhead down to the next print line and returns the carriage to the left margin.

qVertical tabulation (VT) — The printer prints the remainder of the current print line, moves the printhead down to the next vertical tab stop, and returns the carriage to the left margin.

qDevice control 2 (DC2) — The printer moves the printhead down to the print line specified by the DC2 n (Move to Line n) command and returns the printhead to the left margin.

The default setting for the parameter CR W/LF VT DC2 is OFF.

Graphics

When on, this parameter enables the raster graphics escape sequences described in Chapter 4. The default setting is OFF.

Shift Out Equals Expanded Print

When on, this parameter causes the printer to print one line of expanded print after receiving a shift out (SO) command. When this parameter is off, the printer invokes the G1 character set into the GL area of the character table upon receiving SO. The default setting is OFF.

Printer Setup 2-7