When projecting from a table, the ideal arrangement is to set the projector flat on its surface. This way, you can use the lens shift knob (instead of raising the projector’s feet) to position the image on-screen. This delivers the best-looking picture.

You won’t need to tilt the projector upward as long as you position it so that its lens is at least as high as the bottom of the screen, but no higher than the middle of the screen, as shown:

note

After positioning the projector, you may wish to connect a Kensington security lock to the hole on the projector’s left side. This can be purchased from your computer or electronics dealer

or from EPSON. (See page 4.)

no higher than middle of screen

ideal range

no lower than bottom of screen

(If you have to raise the front of the projector, you can use the projector’s keystone correction to eliminate distortion caused by tilting the projector upward. But you’ll still get a better picture if you can leave the projector flat on the table, without extending its feet.)

If you’ll be projecting from overhead, you can get the best-looking picture by mounting the projector parallel to the ceiling, with its lens at least as high as the middle of the screen, but no higher than the top of the screen. Then use the height adjustment knob to position the image on-screen. You’ll also need to select ceiling projection in the projector’s Advanced menu (see page 71).

14Setting Up the Projector