Connecting S-Video or Component Video

Before starting, make sure the projector and your VCR or other video source are turned off.

1.For S-Video, insert one end of an S-Video cable into the projector’s S-Videoconnector. Insert the other end into the S-video-out port of your video source.

S-Video cable

S-Video connector

For component video, connect the three ends of a BNC cable into the projector’s R, G, and B ports. (Don’t connect the cables to the projector’s H/C Sync or VSync ports.) Insert the opposite ends of the cable into the corresponding ports of your video source. If the image doesn’t display properly, you may need to change the BNC parameter in the projector’s Setting menu (see page 69).

2.If you’ll be using audio, connect the RCA audio cable to the S-Audioand Audio2 ports of the projector. Connect the plugs at the other end of the cable to the audio output ports of the video source.

note

Contact your video manufacturer or other video or electronics dealer to obtain a component video cable.

Setting Up the Projector 37